How to set a universal remote control for air conditioner

As a rule, in case of loss or damage to the control panel to turn the air conditioner impossible. To buy a new remote control for specific models of air conditioning does not always work. So buying a universal remote control is the only way. This remote can control any air conditioning. To do this, you must configure the remote to your model of conditioning.

Как настроить универсальный пульт управления к кондиционеру

The principle setting of all remotes is the same and is in the water right code in a memory of the remote control. As a rule, to the control manual, which includes a table codes for different models of air conditioners. To configure the remote control there are two modes — automatic and manual mode.

Automatic mode you can use if you don’t know which you have the conditioning or the code table does not have your model. To configure auto search you need to take the remote in hand and channel on the air conditioner. Look on the remote the SELECT button,press and hold for 5 seconds, then release.

The remote will automatically send commands to the air conditioner and cycle through the available codes. In this case, the display shows the codes will flash and change. As soon as the correct code you will hear a beep from your device and the air conditioner comes on. At this point you should press any button on the remote, scanning codes will be stopped.

Check the operation of the air conditioner with this code. If teams are not performing correctly or some functions do not work, run the car for the codes again until you find the code under which your air conditioner will work correctly.

Setting in manual mode takes less time. Locate the code in the code table to your model of conditioning, there may be several. Press the «SELECT» button, with code on the display should blink once. Use the numeric buttons to enter the code into the memory of the remote control and press the «ENTER» button, the remote is programmed.

Check how commands are executed by the air conditioning. If you don’t correct the air conditioning system, try to enter the queue for the other codes. Also to sort through the codes using the buttons «TEMP+» and «TEMP-«.

After entering the correct code, the remote control air-conditioning is ready for operation. You will have access to all basic functions. With the remote you can select the operation mode of the air conditioner is cooling, heating, ventilation, auto mode. You can set the desired temperature, adjust the fan speed and choose the direction of air flow.

Post Comment